The expression “double-ended stud” does not remove the need for a complete drawing. An enquiry may involve equal threaded ends, different thread lengths or a special combination of diameters and thread requirements. A labelled End A and End B schedule makes the intended product easier to review without relying on the reader's interpretation of a short trade description.
Draw the complete part and label both ends
Use an approved view showing End A, End B and the centre section. State the overall-length convention and all dimensions needed to define the transitions. A supplier should not have to subtract two thread lengths from an uncertain overall length to decide the intended plain section. Where dimensions are related, have the designer establish the governing values and tolerances.
Identify chamfers, points, reliefs or other end details where required. If the part is based on a standard, specify the applicable reference and describe the approved departures clearly. Do not assume that a drawing for a symmetrical part can be reused unchanged for one with a different requirement at one end.
Build an end-specific schedule
Keep the two ends in separate fields, even where their values are identical. This makes later changes visible and helps prevent a supplier from applying a revised requirement to both ends. Use the same end labels in technical questions, quotation clarifications and inspection reports.
- End A: thread designation, direction, tolerance requirement and thread-length definition.
- End B: the corresponding requirements, stated independently.
- Centre section: diameter, length and any approved transitions.
- Overall length: measurement endpoints and tolerance.
- Material and finished condition for the complete component.
- Drawing revision, quantity and inspection requirements.
Identify the actual mating arrangement
State which end connects to which mating component, using drawing or item references. Where one end is intended for a tapped component and another for a nut, have engineering define the applicable fit and engagement requirements. Do not infer them from whichever end appears shorter in a photograph.
For a custom combination, ask the supplier to acknowledge both end definitions in the quotation. Record any proposed change explicitly and obtain the required approval before ordering. A substitute with the same overall length and main diameter may still have a different thread arrangement or mating condition.
Inspect the two ends as separate characteristics
Assign report references to End A and End B so their measurements cannot be confused. Agree how the part will be oriented during inspection and how the record identifies that orientation. If the ends are visually similar but functionally different, have the buyer approve a suitable identification or packaging method. Do not introduce a marking that conflicts with required grade or manufacturer identification.
Retain the approved schedule with the final dimensional report and lot references. At receiving, compare the supplied part identity with the current drawing, not just a shortened packing-list description. For a repeat purchase, review both ends and the mating-component revisions before reusing an old order line. This schedule supports a complete procurement definition; it does not replace engineering approval of the assembled joint.
Send the approved requirements for review
Send the drawing or full specification, quantity and destination to XZ Fastener for a manufacturing and quotation review. Include material inspection reports, dimensional reports and batch traceability in the requested document scope. Any EN 10204 3.1/3.2 or third-party inspection requirements need their issuing arrangements, scope and buyer approval confirmed before ordering.
For the wider purchase file, use our project fastener order control records. The stud length guide addresses overall and effective thread length separately.