A hole running along the length of a stud needs a different drawing review from a transverse cross hole. A photograph of the opening cannot show the internal geometry, depth reference or acceptance requirements. Resolve these details before asking a supplier to quote a drawing-based part.
Define the hole from a controlled reference
Show which end the hole enters and the datum used to locate it. State whether it is blind or through, and distinguish the specified depth from any overall length reference. Where the end form affects the way depth is measured, have the drawing owner define the intended convention.
For a two-ended stud, identify End A and End B consistently across the drawing, parts schedule and inspection report. Avoid descriptions such as “drill this side” on an unlabelled image; the orientation may be lost when the image is printed or separated from the enquiry.
Describe the finished condition
List the required opening and edge condition, any internal thread and any intersection with another feature. Do not leave the supplier to guess whether a machining mark, burr or remaining chip is acceptable. Define the cleanliness and inspection criteria that the actual application requires.
An axial hole changes the component geometry. Its suitability, material requirements and permitted dimensions belong in the approved design. This enquiry checklist does not establish a load rating or approve drilling an existing stock stud.
Agree how the hidden feature will be verified
- Identify each characteristic to be recorded, including the depth reference.
- Agree the measurement or examination method and required access.
- State the sampling or individual inspection requirement in the purchase documents.
- Clarify whether a witness, demonstration sample or retained reference is required.
- Link the report to the drawing revision and inspected production lot.
A photograph of the opening may help identify the part, but it should not be accepted as proof of an internal dimension it cannot show. If a feature cannot be verified after a later operation, schedule the agreed check at the appropriate stage.
Review the manufacturing and handling proposal
Ask the bidder to identify any limitation affecting the requested geometry, inspection or final condition. Resolve an alternative process or geometry through the drawing owner’s approval rather than treating it as a routine workshop adjustment.
Where end protection or internal cleanliness is specified, include it in the packing requirements. State whether temporary protection must be removed before use and what identification should remain with the parts. These details should be agreed with the end user instead of assumed by the supplier.
Prepare the enquiry for review
Send XZ Fastener the complete drawing, material requirement, quantity, final finish and inspection schedule. Feasibility and the document scope need to be confirmed against the actual feature. Request dimensional reports and batch traceability, with material inspection reports as required; agree any third-party or EN 10204 documentation scope before ordering.
Utilisez le custom fastener enquiry form. For a transverse feature, use the separate guide to cross-drilled fastener drawings; for orientation, keep an End A and End B schedule.