Tiếng Việt 
English 
Español 
Русский 
العربية Fasteners used in steel structures are not ordinary workshop hardware. They hold beams, plates, brackets, base frames, towers, platforms, and heavy steel members together. If the bolt, nut, washer, coating, or installation method is wrong, the connection may still look complete but fail inspection or lose performance in service.
For project buyers, the first rule is simple: select the full bolting assembly, not only the bolt size.
Common Fasteners Used in Steel Structures
Steel structures usually require bolts, nuts, washers, anchor bolts, and sometimes special fabricated fasteners. Each type has a different role.
| Fastener Type | Common Use | Buyer Check |
|---|---|---|
| Hex bolts | General steel connections | Grade, thread length, coating |
| Heavy hex bolts | Structural and high-load joints | Standard, nut, washer match |
| Tension control bolts | Controlled structural tightening | Project standard and installation tool |
| Anchor bolts | Base plates and foundations | Embedment, projection, grade |
| Hardened washers | High-strength bolted joints | Hardness, ID, OD, thickness |
| Custom bolts | Special steel assemblies | Drawing, tolerance, inspection |
Buyers can review bolt products and standard fasteners when preparing common structural RFQs.
Key Standards to Confirm
ASTM, EN and Project Specifications
The applicable standard depends on the project market and engineering design. U.S. structural projects often reference ASTM and RCSC requirements. European projects may require EN structural bolting assemblies.
| Standard / System | Typical Application | Key Concern |
|---|---|---|
| ASTM F3125 | High-strength structural bolts | Grade, type, style, marking |
| RCSC Specification | Structural bolted joints | Installation and inspection rules |
| EN 15048 | Non-preloaded structural bolting assemblies | SB assembly and traceability |
| EN 14399 | Preloaded high-strength assemblies | HV/HR system and washer matching |
| Project drawing | Job-specific design | Final authority for procurement |
Do not replace one structural standard with another without written project approval.
Selection Tips for Buyers
Match the Assembly
A structural bolt should be ordered with the correct nut and washer. A high-strength bolt with a low-grade nut is not a high-strength assembly.
Confirm:
- Bolt standard and grade
- Nut standard and grade
- Washer type and hardness
- Thread pitch and thread length
- Surface finish
- Required test reports
- Batch traceability
For load-bearing joints, review high-strength fasteners before confirming the order.
Check Coating and Site Environment
Outdoor steel structures usually need corrosion protection. Common choices include hot-dip galvanizing, zinc flake coating, zinc plating, or stainless steel where specified.
Coating affects more than rust resistance. It can change thread fit, nut running behavior, and tightening results. For corrosion-sensitive projects, compare various coated fasteners.
RFQ Checklist
A complete RFQ should include:
- Product type and standard
- Diameter, length, pitch, and thread length
- Grade and material
- Nut and washer requirements
- Coating or finish
- Connection type: snug-tight, non-preloaded, or preloaded
- Required documents and inspection reports
- Packing and label requirements
For special lengths, non-standard heads, or drawing-based structural parts, use custom non-standard fasteners. For broader sourcing, review the full fastener products range.
Final Advice
Fasteners for steel structures should be selected by standard, load, coating, installation method, and inspection requirement. A clear assembly specification prevents wrong deliveries, site rejection, and unsafe connections.